Geckollect.com support
Back to product Print in PDF formatGeckollect-GE
Technical Data Sheet and Declaration of Conformity
Geckollect-GE is a reed contact module for pulse counting
Main characteristics:
- Pulse-based operation
- No power supply needed
- High sensitivity
- 10W switching power
- Waterproof, solid design
- Between G2.5 and G6: 1 pulse = 0.01 m³
- Between G10 and G65: 1 pulse = 0.1 m³
- Designed for Elster, Honeywell, Kromschröder gas meters
General description:
The Geckollect-GE pulse transmitter unit can measure the consumption of properly designed gas meters and make it available in a pulse signal.
The device implements a so-called low-frequency transmitter, which, after the amount of consumption determined by the meter, behaves like a pressed switch, thereby indicating to the remote reading unit that consumption has occurred on the meter.
Geckollect-GE reed contact module
Installation and Operation:
The device must be inserted into the corresponding opening of the gas meter, and then the fixing screw must be screwed in (it can also be sealed).
When the magnet (Totaliser) arrives, the circuit changes from previously open to closed. This gives the pulse signal.
A reading device capable of reading pulse data is required for its operation. No power supply is required for operation.
According to the gas meter manufacturer's data sheet, the pulse width and resolution are fixed and cannot be changed.
Thanks to the design of the sensor, it is waterproof, but it is not recommended to bury the cable freely in the ground or expose it to direct strong sunlight, as this can damage the insulation. The cable is not shielded.
Maximum and recommended specifications:
| Parameter | Min. | Typical | Max. | Unit |
|---|---|---|---|---|
| Storage temperature | -30 | 20 | 80 | °C |
| Operating temperature | -20 | 20 | 60 | °C |
| Humidity | 100 | RH % | ||
| Operating voltage | 5 | 48 | V (DC) | |
| Current | 100 | mA (DC) | ||
| Power | 10 | W |
Violation of these limits may cause irreparable damage to the device.
Please note that the device contains a sensitive reed switch, so it is highly sensitive to shocks and rapid temperature changes - handle with caution.
Sizes and electricity info
Measuring head:
| High | 29 mm |
| Width | 65 mm |
| Depth | 13 mm |
| Cable length | 1000 mm |
Geometric sizes are without the cable. The length of the cable may very a few percent.
| red cable | pulse + (polarity independent) |
| black cable | pulse - (polarity independent) |
Standard Compliances, Classifications and Liability:
The product meets the criteria of European Commission Directive 93/68 of July 22, 1993.
The product is made with RoHS compliant components and technologies.
After the product has been cut into pieces or in a defective state, it is not municipal waste, it is considered electronic waste, its handling must be carried out in accordance with the applicable legislation.
The device is sensitive to electrostatic discharge. Please handle with extra care.
Class III contact protection product. You can verify the certification of your power supply by contacting the manufacturer.
PLOMBA Kft., as a manufacturer, guarantees the standard conformity described in the Declaration of Conformity. The manufacturer is not responsible for possible problems of standardization and/or legality resulting from incorrect use. This document may change without notice, so we recommend saving or printing this document when purchasing the product in order to avoid misunderstandings later.
The manufacturer's products do not have additional metrology markings. The manufacturer's products are not certified and approved for critical medical, pharmaceutical, radiation protection or military applications.
Declaration of Conformity:
This Declaration of Conformity is issued under the sole responsibility of PLOMBA Kft. (as manufacturer).
PLOMBA Kft. certifies that the Geckollect-GE reed contact module complies with the following EU directives and relevant Hungarian legislation:
| EU directive | Hungarian legislation | Justification | |
| Electromagnetic compatibility | 2014/30/EU | 8/2016. (XII. 6.) NMHH r. | It falls under Section 1 (3) b |
| Measuring instruments (MID) | 2014/32/EU | 43/2016. (XI. 23.) | does not fall under § 1 (1) |
| Hazardous materials (RoHS) | 2011/65/EU | 374/2012. (XII. 18.) Govt. r. | complies with Annex 1 |
| Electrical products (LVD) | 2014/35/EU | 23/2016.(VII. 7.) NGM r. | complies with § 3 and Annex 2, Class III contact protection |
As the issuer of this Declaration of Conformity, we declare that only qualified components were used in the manufactured device, and that the applicable legal regulations were complied with during the design and assembly.
The quality control of the product was carried out within the framework of the factory production control system, with the manufacturer's self-inspection.
Budapest, 2023.10.10.
Beke Roland
Managing director
PLOMBA Kft.
1136 Budapest, Hegedűs Gyula u. 45-47.